Week 4: FYP 2: Design circuit

Title : Design circuit for project
Objective : To build the circuit of this project.
Procedure/Content : 1) Design circuit by using software
                    2) Print the design on the transparent paper
                    3) Stick the design with the PCB board
                    4) Drill and solder all the component
                    5) Test running the circuit with the program

Result:-

Figure 1: PCB board

Figure 2: Aching process

Figure 3: Soldering complete circuit

Figure 4: Complete circuit

Analysis:-

The hardware circuit is design by using PCB board. To complete this design, we need to follow the step above. The first one, we need to aching the PCB board and then solder the circuit to make sure each line will be connected with each other line.

Conclusion: -

For the conclusion after we design the circuit diagram in the program software, we try on the PCB board to construct the circuit follow in the software. The software help a lot on the design of circuit, follow the PIC pin configuration and the port that we decide construct on the PCB board.